View Full Version : soldering psgroove device into ps3
09-28-2010, 03:11 PM
right have a spare spi 360 flasher that i use as my ps groove device, now the question is am i able to solder it into the usb port internally so i can use the same usb port from outside therefore freeing up the port and having a permanent psgroove device?
09-28-2010, 03:36 PM
I think you would either need to change the code, or install a switch.
The current PSGroove code does not appear to properly disable the USB device or be able to detect a warm boot. So on a warm start you would get "Unrecognized USB Device" messages, and that USB port probably wouldn't work properly.
Powered by vBulletin® Version 4.1.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.