Yesterday my xbox developed the 0110 error code. It froze after 1 minute of startup, the next time i turned it on it gave me the 0110 which is to do with the ram chips.

As the xbox has never overheated at all, do you suppose its just a little cold solder joint under the ram chip thats worked its way loose?

How should I fix this, would a little bit of heat gunning over the ram chips work fine?

Or should i do the towel trick? And how do I do the towel trick?

Or should I do it with a blow torch?

Should I put a little flux under the chips before I heat it up to let the solder reflow better again?

I reckon I just need to do a simple reflow on the top ram chips with a heat gun?

Any Ideas, also don't tell me to send it back to Microsoft, as the case has already been opened and the warranty void.

Thanks