reset glitch install pics for noobs

[saleem]

this is by no way aguide,we always see the pics on the net and so you know its done by a real person with about 7/10 soldering skills which is what you will need (or around that)

the posistioning and install of the coolrunner:


a little close up so you know what you are dealing with:



bottom:


closer pic of one point on bottom,this i consider to be a bit more difficult as the resistors are about a mm away and the point is about 1 mm big:


hooked up to tv:


xell:


games on hdd:


xexmenu:


when you put it back together just put a little bit of tape over them solder points on the bottom.

[rory2005]

lol saleem, youve hidden your cpu key on the fuse sets but right below is the complete cpu and dvd keys, i will put some pics up soon of an install im doing shortly.

give you a couple of pointers mate with the pics.

[saleem]

thankyou for that

been a while since i took a soldering iron to a console,so was a bit rusty and didnt notice things like that,must have had my sleepy goggles on.

[rory2005]

it will have to be tomorrow customer didnt come till late and discovered my camera is rubbish in the darkish conditions on macro mode, got digi microscope so will play tomorrow

[rory2005]

hi as promised my install pics, theres no need for the blue wire to go down the underside of the boards, just run it near the heatsinks for a nice tidy install.

[rory2005]

missed some and had to show off my modded case,

anyway my tips are
1 pre tin all the solder points
2 cut the orange cable tip as short as possible so no excess bare cable can make contact with the other pads around it.
3 run the blue cable on around the edge of the heatsinks on the topside of the board to the solderpoint in pics.
4 run the yellow and green cables like in my picture.
5 the point where the green cable terminates, the little solder dot between the capacitor (brown) and resistor (black), can be bridged to the black resistor below to create a larger point to solder to. once again with this point having a lot around it needs the have the excess cable from the tip trimmed to the minimum.

[fanni]

Have done a few of these myself now only arse ache about it is getting the slim to boot at a consistent and decent time

Will take some pics next time i do one

[placidsheep]

How much do you charge to do the install?

[rory2005]

£50 same as saleem and most other people.

going rate

[billysastard]

How much do you charge to do the install?

in a thread full of modders it might be wise to say who you are asking

[rory2005]

lol billy thats very true

[placidsheep]

Lol being human and british.. I was obviously asking whoever is cheapest

[rory2005]

the answer to that is no one ,we are equally expensive lol

lol should be cheap

[thewasher]

Surely you mean equally cheap?

[placidsheep]

So can you explain what happens once its done?

How do I keep it all upto date? say a new dash comes out how would I get a new modded dash on my xbox? never had a JTAG or anything like that...

I don't want to have to be sending it back every 5mins for updates and what not